AZ-700 Questions and Answers
Question # 1
You have two on-premises datacenters.
You have an Azure subscription that contains four virtual networks named VNet1 VNet2, VNet3, and VNet4
You create an Azure virtual WAN named VWAN1. VWAN1 contains a single virtual hub that is connected to both on-premises datacenters and all the virtual networks in a full mesh topology.
You create a route table named RT1.
You need to configure VWAN1 to meet the following requirements:
• Connectivity between VNet1 and VNet2 and both on-premises datacenters must be allowed.
• Connectivity between VNet3 and VNet4 and both on-premises datacenters must be allowed.
• VNet1 and VNet2 must be isolated from VNet3 and VNet4.
How should you configure routing for VNet1 and VNet2 and for both on-premises datacenters? To answer, drag the appropriate route tables and route table propagation to the correct requirements. Each route table and route table propagation may be used once, more than once, or not at all. You may need to drag the split bar between panes or scroll to view content.
NOTE: Each correct selection is worth one point.
Question # 2
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals- Some question sets might have more than one correct solution, while others might not have a correct solution.
After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.
You have on Azure subscription that contains an Azure Virtual WAN named VWAN1. VWAN1 contains a hub named Hub1.
Hub! has a security status of Unsecured.
You need to ensure that the security status of Hub1 is marked as Secured.
Solution: You implement Azure NAT Gateway.
Does this meet the requirement?
Question # 3
You are planning the IP addressing for the subnets in Azure virtual networks. Which type of resource requires IP addresses in the subnets?
