Weekend Special Sale - Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: mxmas70

 
Home > Cisco > Cisco Specialist > 648-238

648-238 Implementing Cisco Connected Physical Security 1 Question and Answers

Question # 4

Refer to the exhibit.

Cameras and a Cisco VSM server are connected to a Layer 2 switch. Which three steps will allow the Cisco VSM servers to see video traffic from the two IP cameras? (Choose three.)

A.

GigE 0/10 should be configured to accept traffic from all VLANs using the #switchport mode access vlan all command.

B.

GigE 0/10 should be configured to dynamic mode using the #switchport mode dynamic desirable command.

C.

Implement "router-on-a-stick".

D.

Implement inter-VLAN routing.

E.

The link between GigE 0/5 and FE 1/1 should be configured as a trunk port.

Full Access
Question # 5

Which camera and lens setup is correct to use IR lighting?

A.

color camera with IR corrected lens

B.

a camera with day/night mode and IR corrected lens

C.

a camera with day/night mode and varifocal lens

D.

color camera with varifocal lens

Full Access
Question # 6

How should the camera capacity for media servers be calculated?

A.

The CPS-MSP-1RU-K9 can handle up to 32 cameras. The CPS-MSP-2RU-K9 can handle up to 100 cameras.

B.

Camera capacity should be calculated by the available storage space on the media server

C.

Camera capacity should be calculated by the aggregate bit rate of all video streams, both inbound and outbound, on a media server

D.

Camera capacity cannot be calculated, and must be configured on site

Full Access
Question # 7

Mr. Cooper, branch security manager at a retail bank, is asked to create a centralized surveillance solution using Cisco VSM. However, the WAN link between HQ and some of the branches has very limited bandwidth. Using Cisco VSM, flexibility of deployment is broad. Which three changes make more efficient use of the limited bandwidth? (Choose three.)

A.

Deploy centralized Cisco VSM solution using H.264 instead of MJPEG encoding in branches with limited WAN speed.

B.

Retain camera recordings on local branch servers, and access video from HQ only when needed.

C.

Configure cameras for H.264 encoding and 15 FPS, store video locally on a server, then transcode the same video stream to 5 FPS before sending it to HQ security center.

D.

Configure dual streaming on each camera, one for high-quality local recording and the other for streaming to HQ over WAN.

E.

Enable multicast within the branch network and unicast video streams when traversing the WAN.

Full Access
Question # 8

Refer to the exhibit.

An operator is trying to set a lower video stream quality for a newly installed camera in the system. However, the video quality slider is grayed out and is not available. What is causing this issue?

A.

The operator does not have sufficient privileges to configure video stream properties.

B.

The camera only supports PAL settings, while the operator belongs to other location using NTSC standard only.

C.

The operator needs to ask an admin to log in and perform the changes to video quality settings.

D.

The operator should use a custom template.

E.

Camera is offline.

Full Access
Question # 9

Cisco VSM services can be started, stopped, or restarted by using the Linux CLI. How do you stop the Cisco services on the server via the CLI?

A.

/etc/init.d/cisco stop

B.

/etc/init.d/cisco_all stop

C.

cisco stop

D.

/usr/init.d/cisco stop

Full Access
Question # 10

As the system administrator, you have been asked to immediately delete cameras in Cisco VSM that are located at a building that was recently vacated by your company. However, due to security and corporate retention policy, you must keep the archived video for 14 days. What method does Cisco recommend to accomplish this task and ensure that the retention policy is met?

A.

"Soft Delete" the camera.

B.

Connect to the Cisco VSM server via FTP and transfer the video files to another server.

C.

Select the Retain Video and Blacklist option when deleting the camera.

D.

Set up Advanced Recording features and use an LTS server for retaining archives.

Full Access
Question # 11

Which four camera configurations are valid? (Choose four.)

A.

CIVS-IPC-3530:1280x720 at 30 fps

B.

CIVS-IPC-3530:1280x800 at 30 fps

C.

CIVS-IPC-3530:1920x1080 at 5 fps

D.

CIVS-IPC-6030:1280x720 at 30 fps

E.

CIVS-IPC-6030:1280x800 at 30 fps

F.

CIVS-IPC-6030:1920x1080 at 15 fps

Full Access
Question # 12

Which Cisco Video Surveillance IP cameras can be configured as an indoor, vandal-resistant camera, without the use of a third-party external enclosure?

A.

CIVS-IPC-3520

B.

CIVS-IPC-3530

C.

CIVS-IPC-4500E

D.

CIVS-IPC-6000P

Full Access
Question # 13

What is the advantage of using multicast instead of unicast to transport the camera video stream in the Cisco Video Surveillance solution?

A.

When the video stream is viewed on multiple operator workstations, the network is taxed only with single multicast stream.

B.

Multicast configuration on switching and routing infrastructure is less complex than the configuration for unicast traffic.

C.

You can configure one camera to stream to two media servers at the same time, for data redundancy purposes.

D.

Multicast is not supported in the Cisco Video Surveillance solution.

Full Access
Question # 14

Refer to the exhibit.

You are the system administrator for a newly deployed Cisco Video Surveillance solution. Branch A cameras are streaming to Cisco VSMS-A and Branch B cameras are streaming to Cisco VSMS-B. Cisco VSOM is reporting a "Timed out waiting for server response" error when trying to load video from camera 192.168.1.102, but network pings are being responded to from your workstation at HQ. All other cameras from the 192.168.1.0 network are working as expected. Which three options could have caused the error message? (Choose three.)

A.

There is a network configuration issue with the switch and switch port that camera 192.168.1.102 is connected to.

B.

Media server 192.168.1.10 is down and not responding.

C.

The Branch A and HQ routers are updating their routing tables and they have not yet converged.

D.

There is an IP address conflict on the 192.168.1.0 network.

E.

The password on the camera was changed.

Full Access
Question # 15

Which four Cisco IP camera families natively support medianet? (Choose four.)

A.

Cisco 2900 Series IP Cameras

B.

Cisco 3000 Series IP Cameras

C.

Cisco 4000 Series IP Cameras

D.

Cisco 5000 Series IP Cameras

E.

Cisco 6000 Series IP Cameras

F.

Cisco 7000 Series IP Cameras

Full Access
Question # 16

Using two identical graphics cards, how many monitors can be driven simultaneously for Cisco VSM 6.3.2?

A.

2

B.

4

C.

6

D.

8

Full Access
Question # 17

When configuring the privilege level on a Cisco IP camera, which of the following is not a valid option?

A.

Administrator

B.

User

C.

Monitor

D.

Viewer

Full Access
Question # 18

Refer to the exhibit.

Which statement can be determined from the output shown?

A.

This is the output from the show power inline command.

B.

The connected device is an 802.af class 2 PoE camera.

C.

The switch management IP address is 10.10.10.202.

D.

The PoE device is connected to switch port 7.

Full Access
Question # 19

Which option can affect the performance of the workstation used to display multiple panes of surveillance video?

A.

CPU and memory only

B.

bus speed only

C.

graphics card capabilities only

D.

CPU, memory, bus speed, and graphics card capabilities can affect workstation performance.

E.

CPU, memory, bus speed, and graphics card capabilities will not affect workstation performance.

Full Access
Question # 20

Which of the following can affect the performance of the workstation that is used to display multiple panes of surveillance video?

A.

CPU and memory only

B.

Bus speed only

C.

Graphics card capabilities only

D.

CPU, memory, bus speed, and graphics card capabilities can affect workstation performance.

E.

CPU, memory, bus speed, and graphics card capabilities will not affect workstation performance.

Full Access
Question # 21

By default, which two passwords are NOT configured in Cisco Video Surveillance Manager 6.3.2? (Choose two.)

A.

VSMC password

B.

VSOM root user password

C.

Operator root user password

D.

Linux root user password

E.

MySQL root password

Full Access
Question # 22

Which two of the following Cisco Physical Security MSP servers support an optional secondary power supply? (Choose two.)

A.

CPS-MSP-1RU-K9

B.

CPS-MSP-2RU-K9

C.

CPS-MSP-4RU

D.

CPS-SS-4RU

E.

CIAC-PAME-1125-K9

Full Access
Copyright myexamcollection.com. All Right Reserved.